Connect-Tek Transa PRO 17 Manuál s instrukcemi stáhnout pdf (Strana 113)

5.2.3. TACHTROL 30 Programming & Setup (Spee

This instrument will be set to run in Tachometer mode and configured to

monitor and report on speed of the mixer. Programming can be accomplished

either through the TT display or TACHLINK.

Input Setup

5.2.3.1. Tachometer Mode (section 4.2.2)

All setup will be performed in Tachometer mode.

5.2.3.2. Direction (section 4.2.2.1)

Direction is not utilized, set to None.

5.2

and the instrument is set to react to the raw A

5.2

In o e

(pu s athematically altered to

•

• ponential notation; 6.383 e-1

.3.3. Equation & Units (sections 4.2.2.2 and 4.2.2.3)

No equation is being utilized

input. No units are applied.

.3.4. Logic Low & High(section 4.2.2.4)

Logic Low = 0.6 volts, High = 2.6 volts (TTL)

.3.5. Averaging(section 4.2.2.5)

Averaging will not be used.

• Averaging = Off

• Average period (sec) = 0.00

.3.6. Normalization (section 4.2.2.6.1)

rd r for the instrument to display speed as RPM, the sensor frequency

lse per second) must be normalized or m

revolutions per minute (rpm).

(pulses/sec) x (1 revolution/94 pulses) x (60 seconds/min)= 0.6383 rpm

Therefore, the input must be multiplied by 0.6383 to read in rpm.

Normalization is entered in ex

5.2.3.7. Units (section 4.2.2.6.2)

Enter units as “RPM”

101

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 132 133

Žádné komentáře

Connect-Tek Transa PRO 17 Manuál s instrukcemi Strana 113