Connect-Tek Transa PRO 17 Manuál s instrukcemi stáhnout pdf (Strana 66)

value of normalized units that represents a significant point within the speed,

frequency, period or count range of the input signal that causes a relay to

ribes the condition where the relay is “On”

are open.

ed as cycles per second,

s expressed in the

be e and Non-failsafe.

tputs in both

Tachometer and Counter Mode. Therefore the following discussion

applies in all cases. The terms speed, frequency, period or count are

From the Main screen, depress Menu,

change state. “Energized” desc

and the normally open contacts are closed. “De-energized describes the

condition where the relay is “Off” and the normally open contacts

The frequency, after normalization may be express

gallons per hour, etc. Therefore, setpoint and hysteresis i

same user-defined, normalized units. There are several types of relay

havior divided into two major classifications; Failsaf

This is discussed in great detail in subsequent sections.

Output setup is the same for all Digital and Relay ou

interchangeable for this discussio

, to list the

Change menus.

Depress

to select Change Tach and to display the

Input/Outp s. If the intent is to

configure a Change

Counter.

Depress

ut configuration menu

Counter application, select

to navigate to Digital Output 1. Depress

additio

To enter Digital Output Setup in TACHLINK simply click on the corresponding tab.

nal times to configure other outputs.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 132 133

Žádné komentáře

Connect-Tek Transa PRO 17 Manuál s instrukcemi Strana 66