Connect-Tek Transa PRO 17 Manuál s instrukcemi stáhnout pdf (Strana 67)

Digital Output Setup allows the user to config

can be assigned to a specific norm

switching behavior utilized by Digital Output 1&2

4.2.4.1. Source

Source is a Fixed Range Constant. Each output can be assigned to any input.

The us

ure the outputs individually. Each output

reset in a particular ma

and Relay Output 1&2.

er can decide to assign one or all of the outputs to a single input. The

choices are Input A, Input B, Equation or Off. Input A & B are the

alized values from

From the Digital Output SETUP pages described in section 4.2.4 depress

lized frequency input and to switch on (alarm) and

nner. The following is a very detailed description of setpoints and

norm section 4.2.2.6. Equation uses the mathematical

result from section 4.2.2.2 in addition to Normalization. The output can also

be turned off by selecting Off.

to make

Depress

the Digital Output 1 Setup active.

to toggle through Input A, B, Equation

and Off. Wh plete, navigate to the next

constant using

en com

or save changes as described in

section 4.1.2.

4.2.4.2.

The f

prem

setpoint (alarm

when an alarm

alarm

band relative to the setpoint. Overspeed setpoints have the hysteresis band

Hysteresis Definitions And Setpoint Classifications

unction of hysteresis is to provide a dead band that will prevent

ature release or engagement of a relay in the alarm condition. Each

) value is associated with a hysteresis value that identifies

condition is considered to be resolved (safe) and the relay

state can reset. Hysteresis bias refers to the position of the hysteresis

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 132 133

Žádné komentáře

Connect-Tek Transa PRO 17 Manuál s instrukcemi Strana 67