Connect-Tek Transa PRO 17 Manuál s instrukcemi stáhnout pdf (Strana 39)

functions and tracks the nested menus used in front panel programming.

including Analog output calibration

ation over a

long period of time. (see section 4.2.9) Programming can be accomplished at

d in

it is necessary to have either a TACHTROL

ront panel and TACHLINK programming will be

s between TT/TP10 and TT/TP30. The “10” series

Output, Digital 1 & 2 outputs and the utility RS485

m the GUI and

s on the “30” series.

4.1.

andard

ber to be displayed grows too large

or to any user-

d constants must be input as exponential notation, especially when

xponential notation allows the

wed by an “e”

(exponent) to a given power of 10. If the sign preceding the exponent is

positive, move the decimal point to the right the same number of places as the

value of the exponent, if negative, move the decimal point to the left. When

TACHLINK also allows additional function

(see section 4.2.5.2) as well as the ability to track and plot rate inform

either the installation site or off site, then debugged, with features integrate

the tachometer, all prior to committing to the first “live” run.

When programming a TACHPAK,

plus

TACHLINK to act as the communication gateway. Because of the high

level of similarity, both f

discussed together.

There are functional difference

does not include Analog

serial port. As such the “10” series omits those functions fro

display menus. This discussion of programming focuse

Simply disregard discussion of those options that do not apply.

4.1.1. Basic Programming Rules

1.1. Exponential Notation

This tachometer device is designed to automatically switch from st

notation to exponential notation if the num

o small for the number of digits supported by the display. M

define

programming through the display front panel . E

instrument to support high-resolution measurements and calculations without

the need for an extreme number of digits on the display. For those unfamiliar

with Exponential notation, the format is a base number follo

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 132 133

Komentáře k této Příručce

Žádné komentáře

Connect-Tek Transa PRO 17 Manuál s instrukcemi Strana 39

Komentáře k této Příručce