Connect-Tek Transa PRO 17 Manuál s instrukcemi stáhnout pdf (Strana 99)

4.2.9. Plotting (

TACHLINK Only)

TACHLINK provides a tool that enables the user to m

process over an extended period of time. The plotting tool is com

onitor and track the

patible with

all TACHTROL and TACHPAK tachometers. The data is recorded in one-

oth graphical or spreadsheet

format and can be saved for future analysis.

s disk

4.2.9.1. Plotting Setup

Plotting can track up to 3 sources of information. The Normalized result

of Input A and Input B as well as Equation can be used to form a

graphical plot and be saved as a spreadsheet. Each source has a user-

configurable low and high threshold. These thresholds can be the same as

applied to one of the outputs or other significant values.

Each input source also has a Span number associated with it. This is an

output from the Plotting tool and is not user-configurable. Span keeps a

running number when Plotting is active of the difference between the

maximum and minimum values for each input source. The result is SPC-

type information about the process being monitored. Span can be reset by

exiting TACHLINK; then re-entering.

second intervals and can be presented in b

Plotting uses approximately 8 to 12 MB of memory per day depending on

how many plots are being created and will run indefinitely as long a

space permits.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 132 133

Žádné komentáře

Connect-Tek Transa PRO 17 Manuál s instrukcemi Strana 99