Connect-Tek Transa PRO 17 Manuál s instrukcemi stáhnout pdf (Strana 122)

Direction is utilized to allow the instrument to increase positive speed in a

rd se speed in a reverse (target ccw)

or is being used, the

tio . The instrument will be set to

5.3

aw A

input. No units are applied.

5.3.5.5. Averaging(section .2.2.5)

e speed reading.

5.3

ormalized or

• ormalization is entered in exponential notation. 0.0006383 = 6.383 e-4

5.3 2.2.6.2)

5.3 ut Type (section 4.2.2.6.3)

elect Frequency.

5.3.5.9. Min Freq(section 4.2.2.6.4)

in frequency = 0.100

forwa (target cw) direction and decrea

direction. Since an AI-TEK Bi-directional sens

direc n logic signal will be utilized

increase positive speed in the forward (target cw) direction with the

Direction Bit High.

.5.3. Equation & Units (sections 4.2.2.2 and 4.2.2.3)

No equation is being utilized and the instrument is set to react to the r

5.3.5.4. Logic Low & High(section 4.2.2.4)

Logic Low = 0.6 volts, High = 2.6 volts (TTL)

Averaging will be used to help smooth out th

• Averaging = On

• Average period (sec) = 0.5

.5.6. Normalization (section 4.2.2.6.1)

In order for the instrument to display and react to linear speed of the stage,

the motor rotation (pulses per second) must be n

mathematically altered to linear units (inches) per minute.

• (1 revolution/94 pulses) x (1 inch/1000 revolutions) x (60 seconds/min)=

.0006383 inches/min

• Therefore the input must be multiplied by .0006383 to read in inches/min.

.5.7. Units (section 4.

Enter units as “Inches/Sec”

.5.8. Inp

110

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 132 133

Žádné komentáře

Connect-Tek Transa PRO 17 Manuál s instrukcemi Strana 122