Connect-Tek Transa PRO 17 Manuál s instrukcemi stáhnout pdf (Strana 94)

4.2.7. Verify

TA nd verification

of a user-defined configuration prior to committing the instrument and

process to a “live” test. Verify allows the user to configure setpoints and

outputs, then apply a simulation of the expected speeds or counts to the

annel has an independent

nt. s and units used in Verify should

eter in normal

ple, a sensor from an application is producing a 1000 Hz signal.

The Normalization constant is 1.111 e0 and converts the frequency to

allons per hour and no math equation is applied. Therefore, the number that

ppears on the display, and used for all outputs is 1111 Hz and is the number

m e.

Verify is active (On) on any display, all other displays are locked until

Verify is released (Off). Verify overrides current operation of the

instrument.

a simple and convenient method

e rovide security unless a

d placed in an appropriate

CHTROL a TACHPAK tachometers are designed to allow

instrument to see how each will react. Each ch

Verify consta The user –defined value

be the same as those applied to the outputs by the tachom

operation.

For exam

to be applied in Verify od

When

An external switch hard-wired to the tachometer allows

to initiate Verify (see section 3.4.3). This m thod does not p

keyed switch is used. An appropriate switch can be wired an

location

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 132 133

Žádné komentáře

Connect-Tek Transa PRO 17 Manuál s instrukcemi Strana 94