Connect-Tek Transa PRO 17 Manuál s instrukcemi stáhnout pdf (Strana 123)

Dig uital Outp t 1 Setup

5.3

avigate back to Digital Output 1 setup. Select Input A for source.

.4.2.1)

)

desired. Enter 0.00 for both.

inear speed does not exceed 1

ion.

Enter 9.000e-1 for the Safe setpoint.

Digital Outpu

.5.10. Source (section 4.2.4.1)

5.3.5.11. Latch Mode (section 4.2

Select Off

5.3.5.12. On / Off Delay (section 4.2.4.2.2

No delay is

5.3.5.13. Output Switching (section 4.2.4.4.

Digital 1 is being used to ensure that the l

inch per minute in the forward (positive) direct

• Select EA (energize above)

• Enter 1.000e+0 for the Alarm setpoint.

•

t 2 Setup

Navigate to Digital Output 2 setup. Make all constants the same except for Output

switching.

witching (section 4.2.4.4.2)

per minute in the reverse (negative) direction

• Select EB (energize below)

oint

setpoint.

Relay Output

5.3.5.14. Output S

Digital 2 is being used to ensure that the linear speed does not exceed 1

inch

• Enter –1.000e+0 for the Alarm setp

• Enter –9.000e-1 for the Safe

1 & 2

None of these functions are being used and Source for each should be set to None.

Analog Output Setup

Navigate to the Analog output section. –20 to +20 mA will be used. 20mA

will be the max forward speed, 0mA will be stationary and –20 will be

5.3 rce (section 4.2.5.1.1)

max reverse speed.

.5.15. Sou

Set source to Input A.

111

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 132 133

Komentáře k této Příručce

Žádné komentáře

Connect-Tek Transa PRO 17 Manuál s instrukcemi Strana 123

Komentáře k této Příručce